Product operating manual

Specifications:

Minimum operating pressure: 10 Bar

Maximum operating pressure: 150 Bar

Operating temperature: 10 - 70C

Warning:

Operating above 15 Bar may damage the 

Block cylinder and will void the warranty.

Note:

Actual force may vary by 10% - 15% due to friction loss.

Specifications:

Minimum operating pressure: 10 Bar

Maximum operating pressure: 150 Bar

Operating temperature: 10 - 70 ?C

Warning:

Operating above 150 Bar may damage the 

Compact cylinder and will void the warranty.

Note:

Actual force may vary by 10% - 15% due to friction loss.

Specifications:

Minimum operating pressure: 10 Bar

Maximum operating pressure: 70 Bar

Operating temperature: 10 - 70 C 

Warning:

Operating above 70 Bar may damage the 

Swing clamp and will void the warranty. Never allow the Swing Clamp lever to 

contact the fixture or work piece during 

the swing stroke

Note:

Actual force may vary by 10% - 15% due to friction loss

1. Ensure the clamp and work piece surfaces are flat and in line.
2. Adjust levers and bolts so the contact surface  is close to parallel with the mounting flange.
3. Keep the lever angle under 20 degrees to prevent deflection.

Specifications:

Minimum operating pressure: 10 Bar

Maximum operating pressure: 70 Bar

Operating temperature: 10 - 70 C

Warning:

Operating above 70 Bar may damage the 

Link clamp and will void the warranty.

Note:

Actual force may vary by 10% - 15% due to friction loss. Make sure the clamp mounting flange and lever are parallel to the clamping surface. The lever contact surface should be within + - 2 degrees parallel to the body mounting flange or 90 degrees to the mounting flange face when clamping a work piece

1. Ensure the clamp and work piece surfaces are flat and in line.
2. Adjust levers and bolts so the contact surface  is close to parallel with the mounting flange.
3. Keep the lever angle under 20 degrees to prevent deflection.

Specifications:

Minimum operating pressure: 25 Bar

Maximum operating pressure: 70 Bar

Operating temperature: 10 - 70 C

Warning:

Operating above 70 Bar may damage the 

Work support and will void the warranty.

Note:

Actual force may vary by 10% - 15% due to friction loss

1. Ensure the clamp and work piece surfaces are flat and in line.
2. Adjust levers and bolts so the contact surface  is close to parallel with the mounting flange.
3. Keep the lever angle under 20 degrees to prevent deflection.